,

Jeep Cherokee Enhancement Session

This was a fun task!  The owner of this Jeep had only had the vehicle a number of weeks, but had noticed the blemishes in the paintwork, topped off by a healthy scuff on the drivers side rear arch.  So it was handed over to me.  There was a lot of metal (& plastic being a Jeep….) to cover so it started off with a full decontamination.  It wasn’t too bad overall and only the lower sills really needed work on removing tar.  Then I moved on to polishing.

The headlights were the first things attacked.  They were a bit cloudy and thankfully a good claying removed a lot of the surface gunk which was giving the cloudy effect.  Then the lens’ were treated to a 1500 and 2500 wet sanding before being polished up.  Aside from the odd chip and very deep scratch, they came up really nice, total transforming the appearance of the front end.

The polishing of the body began with firstly taping off black plastics / rubber bits.  Panels were polished in stages with a tough cutting rotary polisher first, then a dual action polisher to refine the finish.  The idea was to improve (in a fairly short space of time) and not to achieve full 100% correction.  This was achieved in all places.  On the bonnet, there were marks symptomatic of someone using a scourer to remove bird droppings…. [ouch!] but a light wet sanding and a good cutting buffing removed them satisfactorily.  Then there was the rear arch.  There are photos below of the process.  I was a little cautious as being a plastic panel, I couldn’t measure the paint depth.  However with over 200 microns on the door just above, I was happy there was sufficient to remove a healthy amount.  I started with 1500 grit paper, then refined with 2500 grit paper (like I did with the headlights) before buffing with a small wool pad, and then refining using the same technique as I was giving the whole car.  Whilst some marks were still visible under the floodlight the improvement was dramatic and the owner was very pleased indeed.

Finally, the truck was given a coat of collinite, the tyres dressed, rubbers and plastics treated to trim gel, and the windows cleaned inside and out with 3M spray cleaner – good stuff!  9 hours of hard work (could have spent more than double that on it!) but very rewarding.