2004 Fiesta – Scratch removal & valet
This was a challenge that I wasn’t sure I could take on, but as the owner gave the go ahead, I decided to carefully tread my way through this rather precarious situation. A little “oik” had drawn pretty patterns into the paint with some kind of object, maybe a stone. Thankfully the stone was not sharp as the scratches were not too deep or narrow. Therefore, I decided that wet sanding would be a good call.
Using an eraser as a small rubber block, I used wet sand grades 1200 to 2500 to gently bring the paintwork around the scratches down to the level of the scratch. I had to regularly stop and take paint depth measurements to ensure I was not at risk of burning / sanding through the clearcoat, which would have meant a respray!
After about 2.5 hours of careful work on the affected bonnet area and the nearside front wing, I was happy with the overall appearance. The paint needed to some serious refining after the sanding due to the roughness of what the act of wet sanding does to the lacquer.
The car (as it was being traded in hence coming to me) was also given a single stage polish (after the usual decontamination work of course) and then valeted inside and tarted up a bit on the outside (rubbers, tyres, plastics, glass, inside and out, alloys washed properly, etc)
Very happy with the results. Here’s some photos.

