Fiat Abarth Spruce up

This Fiat Abarth came to me for probably its first ever polish.. The paintwork wasn’t dreaful but under close scrutiny the defects were quite clear.  So this job was to remove that crappy layer of paint on the surface to dry and find some nice fresh paint to allow that lovely black colour to shine through.

First step was a full decontamination, so the lower half of the car was sprayed with Tardis to loosen off any tar (wasn’t too much anyway) and then given a wash down followed by a full claying.  The polish was done in 2 stages, firstly with a speed glaze to cut through the paint, and then refined with a gentler polish and on less abrasive pad.  As the right hand pic above shows, this combination brought back most of that dark black paint again, compared to what it was like.

To finish off, the car was coated with Collinite 476S, the trims given some trim gel, the wheels cleaned properly and the tyres dressed.  The glass was also polished inside and out.

All in all, not bad for 6 hours work, but I would have liked more time to thoroughly correct many areas a bit more, probably with the help of some mild wet sanding too!